Help – Kenwood KVT-524DVD User Manual
Page 90
90
KVT-524DVD/KVT-554DVD/KVT-54DVDR
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
▲
Subwoofer is not set to On.
☞
(page 58)
▲
Preout is set to "Rear".
☞
62)
▲
The Dual zone function is enabled.
☞
Control> (page 82) ! Cannot set up the subwoofer phase. ▲ Subwoofer is not set to On. ☞ (page 58) ▲ Low pass filter is set to Through. ☞ Network Setup> (page 59) ! • Cannot select the output destination of the subsource in the Dual zone. • Cannot adjust the volume of the rear speakers. ▲ The Dual zone function is disabled. ☞ Control> (page 82) ! Cannot play audio files. ▲ "CD Read" of to "2". ! Cannot Folder select. ▲ The Scan play or Random play function is enabled. ! Cannot perform Repeat play. ▲ The PBC function is enabled. ! • Cannot set up the equalizer. • Cannot set up the crossover network. ▲ The Dual zone function is enabled. ☞ Control> (page 82) ! Cannot watch the source selected as AV-OUT in the rear monitor. ☞ ▲ "AV-OUT Graphic Output" of Setup> is set to "Black". What might seem to be a malfunction in your unit General ? The Touch Sensor Tone doesn’t sound. ✔ The preout jack is being used. ☞ The Touch Sensor Tone can’t be output from the preout jack. Tuner source ? Radio reception is poor. ✔ The car antenna is not extended. ☞ Pull the antenna out all the way. ✔ The antenna control wire is not connected. ☞ Connect the wire correctly, referring to the section on Disc source ? The specified disc does not play, but another one plays instead. ✔ The specified disc is quite dirty. ☞ Clean the disc. ✔ The disc is severely scratched. ☞ Try another disc instead. Audio file source ? The sound skips when an Audio file is being played. ✔ The media is scratched or dirty. ☞ Clean the media, referring to the CD ✔ The recording condition is bad. ☞ Record the media again or use another media. Navigation ? The touch panel control of the navigation system does not work. ✔ Navigation software is not the latest version. ☞ Update the navigation software. For how to Help? Troubleshooting B64-4285-00_00_English.indd 90 B64-4285-00_00_English.indd 90 08.10.31 2:36:30 PM 08.10.31 2:36:30 PM
▲ A source control screen is displayed in front.
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
cleaning of the section on
(page 6).
update the software, refer to the instruction
manual of the navigation unit.