Kenwood SW-21HT - Manual (Page 6)

6
SW-21HT
Controls and indications
1 POWER switch
Switches the power ON and OFF.
2 SLEEP indicator
Lights green when the unit is put to the sleep
mode by the auto power save function.
3 WAKE UP switch
When the unit is put to the sleep mode (which
is indicated by the green lighting of the SLEEP
indicator) by the auto power save function,
pressing this switch cancels the sleep mode.
4 VOLUME knob
Adjusts the volume level of the output of
the Subwoofer. Rotating the knob clockwise
increases the volume level, and rotating the knob
counterclockwise decreases the volume level.
5 AUTO POWER SAVE switch
The auto power save function is activated when
this switch is ON. With this function, the unit enters
the sleep mode when no signal has been input for
30 minutes and the SLEEP indicator lights green.
The sleep mode can be canceled by pressing the
WAKE UP switch.
6 LINE INPUT jack (RCA-type pin-plug)
This jack is used to connect the subwoofer Pre-Out
jack of the amplifi er.
7 Power cord connector
Connect to Power cord.
Caution concerning operation
An excessive input level to the Subwoofer may
impair the sound quality or damage the unit.
Careful attention should therefore be paid to the
following precautions.
• Do not increase the output of the amplifi er to a high
level while the low-frequency level is enhanced by
the amplifi er’s tone control or loudness control.
• When operating the amplifi er switches or when
placing the stylus on an analog record, set the
amplifi er volume to its minimum level.
$A'PINKUJAUKFGKPFD