Av input setup, Av output interface setup, Av input setup av output interface setup – Kenwood DNX4230TR User Manual
Page 45: Av input setup (p.88)
88
88
89
AV Output Interface Setup
You can select an AV source to be output at
the AV OUTPUT port. Default is “VIDEO1”.
1
Touch [Menu] on any screen.
2
Touch [SETUP].
SETUP Menu screen appears.
3
Touch [AV-OUT].
AV-OUT Interface screen appears.
4
Touch [
2] or [3] to set [AV-OUT] to
VIDEO, DISC, iPod, or OFF.
AV Input Setup
You can set AV input parameters.
1
Touch [Menu] on any screen.
2
Touch [SETUP].
SETUP Menu screen appears.
3
Touch [Source].
4
Touch [AV-IN SETUP] in the list.
AV-IN SETUP screen appears.
5
Set each item as follows.
iPod AV Interface Use*
1
Sets the terminal which iPod is connected.
Setting values are iPod and AV-IN2.
iPod (Default): Set this when an iPod is
connected using KCA-iP202
connector. You can listen to
audio or watch video in your
iPod as iPod source.
AV-IN2: Set this when an iPod is connected
using KCA-iP102 connector.You can
listen to audio in your iPod as iPod
source. You can also listen to audio or
watch video output from a AV device
as AV-IN2 source.
AV-IN1 Name/AV-IN2 Name*
2
Sets a name to be displayed when you select
a system that is connected via the AV INPUT
port. Default is “VIDEO”.
*1 This item can be set when in STANDBY
source and also the iPod is disconnected.
*2 [AV-IN2 Name] becomes settable when
“AV-IN2” is selected in [iPod AV Interface
Use].