Kenwood KS-1300HT-B - Manual (Page 3)

English
3
ENGLISH
Installation Methods Installation Methods
On the Desktop or Shelf
Place the speakers on the desktop, shelf or a similar level surface.
On the Wall
The speakers include mount holes for wall mounting. You can hang the front and surround speakers on the wall vertically, and the cen-
ter speaker horizontally.
7 Front speaker , Surround speaker
1. Screw a single screw into the wall at the desired
location. Screw it only part way in, so that the
screw projects 8 to 10 mm (5/16 to 3/8 inches)
outward from the wall surface.
2. Hang the speaker by fitting the top mount hole (at
the upper rear of the speaker) over the extend-
ing part of the screw. Confirm that the speaker is
held firmly and securely in place.
7 Center speaker
1. Screw two screws into the walls 96 mm (3-3/4
inches) apart, making sure that screws are hori-
zontally level. Screw each screw only part way in,
so that the screw projects 8 to 10 mm (5/16 to 3/8
inches) outward from the wall surface.
2. Hang the speaker by fitting the two mount holes
(at the rear of the speaker) over the extending
part of the screw. Confirm that the speaker is
held firmly and securely in place.
Various mounting methods
7 On the optional Kenwood stand (SR-8000)
(front speaker and surround speaker only)
The speaker can be installed on the SR-8000 stand optionally
available from Kenwood.
7 On the commercially available speaker mount or
bracket (front speaker only)
Any commercially available speaker mount or bracket can also be
used (provided that the speaker can be fixed using an M5 screw
with a pitch of 60 mm and effective thread length of 10 to 13
mm).
For details, read the instruc tion
manual for the speaker mount or
bracket.
Attaching the cushions
Attach cushions to the base of the speaker as shown below. The
cushions prevent the speaker from sliding, and dampen its vibra-
tions.
Front speaker, Center speaker
Surround speaker
Precautions
Please observe the following precautions when mounting speakers onto the wall or speaker stand.
• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. front speaker : 0.6 kg [1.3 lb], cen-
ter speaker : 0.6 kg [1.3 lb], surround speaker : 0.5 kg [1.1 lb]).
• Wall screws must be purchased separately.
• Be sure to use screws that are appropriate for the wall or stand you are using, and that are long enough to provide sufficient strength.
• If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of installation,
please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury or damage that
may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient support strength.
8 - 10 mm
(5/16 - 3/8")
96 mm
(3-3/4")
Eff ective thread
length
M5 screw
4 mm
(3/16")
9 mm
(3/8")
4 mm
(3/16")
9
mm (3/8")
4 mm
(3/16")
B61-1332_EN.indd 3 08.4.11 9:47:38 AM