Audio Authority Car Audio System - Manual (Page 46)

46
ASD
Tech Support USA and Canada: 800-322-8346 (Mon-Fri 8:30 AM to 5:00 PM Eastern Time)
Phone: 859-233-4599 Fax: 859-233-4510 Hookup drawings and FAQ http://www.audioauthority.com
DC EXPANSION
915 X
DC POWER BUS
BLK RED BLK RED
1 2 3 4
TRIPPED
PUSH TO
RESET
RIGHT INPUT
LEFT INPUT EQ INPUT BUS
RIGHT FRONT OUTPUT
LEFT FRONT OUTPUT FRONT OUT BUS
RIGHT REAR OUTPUT
LEFT REAR OUTPUT REAR OUT BUS
RIGHT SUB OUTPUT
LEFT SUB OUTPUT SUB OUT BUS
PSB PSB
EQUALIZERS
4 3 2 1
DC
EXPANSION GROUP
10-19
0-9
MODULE ID
ON OFF
BYP
ASS
SYSTEM
BUS
Car Equalizer Selector
ASD
Model 958
701-1093
POWER
EXP
ANSION
0 1
23 4
5
6 7 8 9
S
915X DC
Power
Expander
915X DC
Expander
Connection
System Bus
Connections
Bypass Setting
EQ INPUT
Product Pos. 4
EQ FRONT
OUTPUT
Product Pos. 4
EQ REAR
OUTPUT
Product Pos. 4
EQ SUB
OUTPUT
Product Pos. 4
Front Output
Bus Connections
(IN & OUT)
or to 980 "Bus A"
Processor/EQ: 2 Channel Low-Level Input / 6 Channel Low-Level Output
The same layout applies to 6 and 4-channel processor Product Groups (a 2-channel processor group may use
a 922 for input signal and a 920X for output). The Low-Level Bus connections should be routed to the corre-
sponding bus connections on the next module in the Product Group or the Model 980 System Module (front
output bus to position "A" on the 980A, rear bus to position "B" & Sub bus to position "C"). See Model 980
Setup Diagram for the next installation step.
If your system includes head units with both low-level and high-level signal output, special wiring is re-
quired for setting up the proper installation of Low-Level Bypass (see pp. 12, 42).
Address
Settings
INPUT
(from source or
previous 958)
Bus Connections
Rear Output
Bus Connections
(IN & OUT)
or to 980 "Bus B"
6 Channel
Signal Processor
or Equalizer
Optional 994/995
Product Select
Button or Indicator
Sub Output
Bus Connections
(IN & OUT)
or to 980 "Bus C"
Audio Signal
Expansion Port
Processor (pos. #4)
DC Connections
Switched + (Yellow)
Battery (Red)
Ground (Black)
EQ Bypass Note:
This EQ could not be connected in position #4 as shown if this were the last module in an
Equalizer Product Group to be bypassed.
958
For EQ bypass,
turn the BYPASS
switch ON
DC Power
Connections
From nearest 916X