Siemens ET375MF11E - Manual (Page 15)

15
Automatic time limit
If a hotplate has been switched on for a long time without the
setting being changed, the automatic time limit is activated.
The hotplate stops heating.
” ‰ and the • / œ residual heat
indicator flash alternately on the hotplate display.
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
Basic settings
Your appliance has various basic settings. You can adapt these
settings to your own personal needs.
Changing the basic settings
The hob must be switched off.
1. Switch on the hob.
2. Within the next 10 seconds, touch the
0 symbol for
4 seconds.
3. Touch the 0 symbol repeatedly until the desired indicator
appears on the display.
4. Set the desired value on the settings range.
5. Touch the 0 symbol for 4 seconds.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the main switch
and make new settings.
Indicator Function
™ƒ Audible signal
‹ Confirmation signal and operation error signal are switched off.
‚ Only the operation error signal is switched on.
ƒ Confirmation signal and operation error signal are switched on.*
™† Automatic time limit
‹ switches off after 1-10 hours*
‚ switches off after 0.5-5 hours
ƒ switches off after 0.25-2.5 hours
™‡ Duration of the timer end signal
‚ 10 seconds.*
ƒ n 30 seconds
„ 1 minute.
™ˆ Activation of the filament circuits
‚ Switched off
ƒ n Switched on
„ Last setting before the hotplate was switched off.*
™Š ** Time for selecting the hotplate
‹ Unlimited: the last selected hotplate can always be adjusted without having to select it again.
‚ Once you select a hotplate, you have 5 seconds to adjust it, after which you will have to select it again in order to
be able to adjust it.*
™‹ Resetting to basic setting
‹ Switched off.
‚ Switched on.
*Basic setting
**Only valid for appliances with several hotplates.