beautypg.com

Installation/setup warning safety considerations – Hot Max Torches PL-40 User Manual

Page 7

background image

Installation/Setup

Warning

Safety Considerations

Electric Shock Can Kill

Only qualified personnel should attempt to install this equipment.

Turn off the input power at the fuse box or disconnect switch and discharge capacitors
before working inside the equipment.

Take care not to touch electrically hot parts

Make sure the unit is switched off before plugging it into a the power outlet.

Selecting A Location

The PL-40 should be placed where clean cool air can easily flow in and out of the unit’s side vents. Dirt and
dust can be drawn into the unit resulting in excessive operating temperatures and shutdowns, therefore, dirt
and dust around the unit should be kept to a minimum.

The PL-40 requires a supply of clean, dry air. Oil in the air will cause a problem with the PL-40 and must be
removed. The air supply pressure must be between 60 and 75 psi and the flow rate should be between 3.0 to
3.5 cfm.

The PL-40 should be placed on a stable, level surface suitable to hold the unit’s weight.

Electrical Connections

The PL-40 is rated for 220VAC/110VAC circuits. Use on 40 amp circuit minimum 220V.

Gas/Air Supply Connections

1. 1/4” NPT Female Gas/Air Connection
2. 220 Volt Cord with Plug

Wrap inlet fitting (Not supplied) with Teflon tape and
thread air fitting into 1/4” NPT Female fitting. After pres-
surizing, check for leaks with soapy water.

Adjust gas/air pressure per instructions on page 10.

KDAR Company

5

1

2.