Operation – Hot Max Torches ARC200 User Manual
Page 7

Operation
KDAR Company
6
Powering Up the Welder
The ARC200 works best on a 40 Amp, 2 pole, 240V
circuit breaker. Once the breaker size is confirmed,
plug the welder into the appropriate matching recepta-
cle and flip the power switch to the on position.
Welding Current Selection
Welding current selection is by turn the adjustment
knob on the front of the welder. Turning clockwise
increases the amperage and turning counter clockwise
decreases the amperage. For the best results, the prop-
er current selection is essential. Check the electrode
manufacturer’s recommendations for the proper set-
tings.
Ground Clamp
The ground clamp must be connected so that a circuit
can be completed in order to create the arc required for
welding. The ground clamp can be connected directly
to the work piece or can be connected to a base metal
the work piece is in contact with.
Electrode
To insert the electrode into the 7 position electrode
holder, squeeze the holder to open the jaw and put the
bare end of the electrode into the desired position in
the holder. Release the jaw.
Welding
Strike an arc and begin to weld.
Maintenance
Regular preventative maintenance is not required for
the ARC200 other than keeping dust/dirt away from
the machine. If the louvers become dusty or clogged,
simply wipe the cover off to remove the dust/dirt.
These welders have no user serviceable parts. Please
contact KDAR for any necessary repairs or replace-
ment parts.
Current Adjustment
Knob
Note: If you are new to welding, KDAR sug-
gests you get instruction from a qualified weld-
er prior to attempting to weld. Welding can be
dangerous if proper safety precautions are not
followed.