Electrix Tweaker Traktor Reference - Manual (Page 17)

3. Traktor Pro 2 Mapping Details
17
8 The volume faders become pitch faders. Moving the fader on either channel automatically dis-
ables beat sync on that deck. Passing the center while holding Shift will reset the pitch to zero
(in case the TWEAKER’s fader position is different from the pitch fader position in Traktor).
8 Turning the top encoder scrolls through the pitch fader ranges.
8 Pushing it resets the range to 8%. TIP: You can display the pitch fader range in the deck display
using the Deck Layout preferences.
8 Turning the middle encoder adjusts the crossfader curve (right channel only).
8 Pushing the middle encoder auto-crossfades.
8 Turning the bottom encoder fine-tunes the pitch (only if Sync is off).
8 Pushing the bottom encoder toggles crossfader assign on and off.
3.3 Grid
The left half of the button grid controls deck-A and the right half controls deck-B.
Hot Cues 1-8
Pressing an empty cell stores a cue point. Holding shift while pressing a saved cue point deletes it.
Each cue point type has its own color:
8 Empty Cell: White
8 Grid Marker: Blue
8 Load Marker: Cyan
8 Cue Point: Magenta
8 Loop: Green
FX Presets
There are 4 presets per effects unit. Presets were created using effects combinations. They can be
used as-is, or as a starting point to manipulate with the pads and/or encoders.
8 Pressing a preset once selects the 3 effects.
8 Pressing it again sets the parameters.
8 Holding shift accesses several settings for each deck: FX 1 and FX2 Insert, Sync On, and Key On.
FX On / Hold
There are two On buttons for each FX units. The first, FX ON, toggles the effects on and off. The sec-