AquaStar 20" Round Full Circle Suction Outlet Cover with One Port Manufactured Sump - Manual

VGB SERIES
SUBMERGED, SINGLE OR MULTIPLE UNBLOCKABLE SUCTION OUTLET
IMPORTANT SAFETY INSTRUCTIONS FOR
Model # FCxxx - FULL CIRCLE DRAIN
(xxx = COLOR SUFFIX)
MEETS OR EXCEEDS ANSI/APSP 16-2011
ANTI-ENTRAPMENT/ANTI-VORTEX
READ AND FOLLOW ALL INSTRUCTIONS
▲
WARNING!
IMPROPER INSTALLATION OR USE OF THIS PRODUCT MAY PRESENT A RISK OF HAIR OR BODY ENTRAPMENT AND
DROWNING. Install this equipment in accordance with the instructions provided. Use only with the components and
mounting hardware provided. FAILURE TO FOLLOW THESE INSTRUCTIONS AND/OR USE WITH COMPONENTS NOT
PROVIDED BY AQUASTAR POOL PRODUCTS AND INTENDED TO BE USED WITH THIS PRODUCT MAY RESULT IN IMPROPER
POSITIONING OR FUNCTIONING OF SUCTION OUTLET AND MAY CAUSE SEVERE PERSONAL INJURY OR DEATH.
Model FCxxx
(min 2" pipe size)
Floor 158 GPM @ 1.2 fps
Wall NA
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
• If in doubt about the rating and/or head loss curve of your
system, consult a qualified pool or spa professional and/or your
respective equipment manufacturer(s). Also, double check
with your local building/health authorities regarding single vs.
multiple drain installations, etc.
• A minimum 2" diameter of connecting pipe is required,
pending velocity and GPM calculations. The larger, the better!
DO NOT exceed maximum flow rate(s) of cover or pipe(s) flow
rate(s), whichever is less.
• Replace cover and screws within 5 years.
• SPECIAL NOTES:
• Pool finish should never exceed top of sump.
• Taper pool finish down and away from top (or lower) of sump.
• Top of grate should never be installed lower than the pool
finish.
P 877-768-2717 F 877-276-POOL [email protected] www.aquastarpoolproducts.com
ALL MODELS LISTED BELOW = ANTI-ENTRAPMENT/ANTI-VORTEX AND FOR SINGLE OR MULTIPLE USE
MAX FLOW RATES (PER OUTLET)
MOUNTING POSITIONS (xxx=COLOR SUFFIX)
Rev 032613
FULL CIRCLE MANUFACTURED SUMP INSTALLATION (SINGLE PORT)
IMPORTANT
• Single or Multiple drain use.
• Model: FCxxx
• NOTE: Disposable plaster shield and
center plaster cap included to prevent
debris from entering sump and to retain
shape during pool finish,
MUST BE REMOVED and replaced with
mfr. supplied drain cover and center logo
cap with markings and screws installed
before startup. (Pierce with a sharp object
and pull out to remove)