Assembling your dake tube bender – Dake Model MB100 User Manual
Page 4
Dake Tube Bender Manually operated 08212009
4
Assembling your Dake Tube Bender
1.
Remove your die pin and insert your red handle and the die in the slot of your die body, line up the
holes and reinstall the die pin.
2.
DO NOT tighten the die pin. The pin head should just touch the gray die body. If it is tightened it
will lock up the parts and bend the die body.
3.
Take the piece holder and put it in one of the other holes as shown below. This piece will be in
different locations depending on the diameter of the material.
4.
Take the little holder and place it in the red handle and use the little pin to hold it in place as
shown below.