Bloom Manufacturing LS12W Series - Manual (Page 7)

• To familiarize yourself with the winch, run it for a few minutes to understand the controls and the “feel” of the winch.
• Pay particular attention to the controls and how they operate. Make sure you understand which way the winch will
Section 6 Winch Operation
rotate when the control lever is moved.
• Always make sure that all people are clear of the load and of the cable area before beginning a winching operation.
• Ensure that proper protective wear is worn while operating winch.
• A broken cable can fly in any direction.
• Do not attempt to defeat the relief valve
Winch lifting application:
(1) Attach winch cable to load.
(2) Make sure no one is in the immediate area of the load or of the cable
Do not attempt to defeat the relief valve.
• If you have any doubts about the capability of the winch to lift or move a load, either put a “snatch block” in the line or
get a bigger piece of equipment.
(2) Make sure no one is in the immediate area of the load or of the cable
(3) Begin winching the load slowly, watching carefully to ensure that the load is moving normally.
(4) When the load is positioned where you want it, stop the winch.
DRUM CAPACITY (Feet)
Drum Cable Diameter (inches)
Winch Series
LS8W, LS10W,
LS12W
( )
Designation 3/16 1/4 5/16 3/8 7/16 1/2 9/16 5/8
S ----- 120 70 45 30 25 ----- -----
S8 ----- 260 160 105 75 55 ----- -----
L ----- 175 105 65 45 30 ----- -----
L8 ----- 390 240 160 110 80 ----- -----
XL10 ----- 840 550 340 250 170 ----- -----
Winch Series
(a) Cable Considerations:
As the number of layers of cable on a winch increases, the rated lifting capacity of the winch goes down. If you are
operating at near the top of the drum flanges the effective rating of the winch is about half of what it is on the first layer
Consult your local cable supplier for recommendations on the best type of cable
and hardware to use in your specific application.
operating at near the top of the drum flanges, the effective rating of the winch is about half of what it is on the first layer.
You should, therefore, only keep as much cable on the winch as you need for your job.
For Best Results, Only Use Bloom Replacement Parts 800-394-1139 7