Bloom Manufacturing 2300KC Series - Manual (Page 6)

Winch Series
Base Mount (steel)
Thickness
5/8”
11 UNC
5
HARDWARE
REQUIREMENTS
• You must make sure that your winch is securely mounted in order for it to function
properly and to ensure safe operation.
• The mount must be flat to ensure proper alignment between the gearbox side, the
drum, and the clutch.
• Winches must never be fastened directly to the frame of a truck. Mounting
brackets should be used.
• With a hydraulically driven winch, make sure the hydraulic system is clean and
that all components function properly, especially the relief valve.
Section 4 Winch Break In
• Winches, like any other kind of machinery, require a “break in” to perform well and
to maximize their life.
• Use extreme care when first spooling cable onto the winch. Do not run the winch at
high speeds when performing this operation.
• Make sure that the cable is unrolled in a line ( to prevent kinks ) and slowly inhaul
the winch to install the cable.
• Do not exceed one half rated load or one half rated line speed for the first thirty
minutes of operation. This will ensure that the gears have an opportunity to wear
in properly.
• Periodically, check the gearbox for temperature rises and allow the winch to cool
down between pulls.
THINK S-A-F-E-T-Y FIRST Bloom Mfg Inc. 319-827-1139
CAUTION
Section 5 Winch Installation
CAUTION
PAGE 6 OF 8 2007
Capscrews (Hexhead)
Size
Thread
Grade
Torque / Tightening
(foot pounds)
115
1-1/4”
2100, 2200, 2300