Addonics Technologies Mobile DVDR/RW - Manual (Page 12)

For Sony and Sharp Notebook users Alternative installation procedures
If you encountered system locked up using our standard installation procedures
(Most common with Window 98 SE, Sharp and Sony Notebook computers and
computers with Ricoh Cardbus/PCMCIA Controller) please try to reinstall using
the procedures outlined below:
1. Before installing the CardBus driver, make sure the CardBus is not
Inserted into the PC Card slot.
2. Boot up the system and insert the CardBus driver diskette into Floppy
Drive A
3. Click on the START button, then Settings and open the Control Panel
4. Click on the ADD NEW HARDWARE icon
5. Click NEXT and NEXT again, the screen will say Windows Will Now
Search FOR PNP DEVICES, DO YOU WANT WINDOWS TO
SEARCH
6. Choose NO, I WANT TO SELECT THE HARDWARE FROM A LIST
7. Click NEXT
8. Select HARD DISK CONTROLLERS from the hardware list
9. Click NEXT, and then click HAVE DISK
10. Type A:\Win9xme, then click OK
11. Highlight ADDONICS CARDBUS IDE CONTROLLER, then click
FINISH.
12. Shut down the system. Reboot the system with the CardBus inserted
Inside the PC CARD slot. Make sure the DVD drive is connected to the
Other end of the CardBUS cable and the Drive is powered on.
13. The initialization of the DVD drive may take up to 40 seconds. During
This time, mouse moving may be sluggish. After completing the
Initialization, a new CD ROM drive icon should appear in the My
Computer. You are now ready to use the DVD drive to install the Power
DVD MPEG II decoding software.
Addonics Technologies – Mobile DVD±R/RW Users Guide v 1.0 11