OZ Lifting Products Beam Trolleys OM - Manual (Page 4)

Important Information and Precautions
This manual contains general instructions dealing with the normal installation, operation and maintenance
of the products described herein.
This product should not be installed, operated, or maintained by any person who has not read all the
contents of these instructions. Failure to read and comply with these instructions, warnings, or limitations
noted might result in bodily injury, death, or property damage. Contact the distributor for further explanation
if information is not fully understood.
It is the responsibility of the owner/user to install, test, maintain, and operate these products in accordance
with OSHA regulations, other federal, state, and local regulations, and ANSI standards.
Only trained and qualified personnel shall operate and maintain this equipment.
Maintain Records
Schedule and maintain records of regular inspection and maintenance of the product in compliance with
ANSI standards.
Record your trolley’s Serial Number on the front cover of this manual to allow for easier referencing.
Precautions
Do not use OZ Lifting products in conjunction with other equipment unless the system designer,
manufacturer, installer, or user has put the necessary safety devices in place.
Modifications to upgrade or alter these products should only be authorized by the original manufacturer.
These Trolleys should be used for holding loads only within their load ratings.
Standards: CE, AS1418.2, ANSI B30.10
(For use with manual or powered hoists)
pg.4
Warnings
Failure to read and comply with the following warnings may result in a hazardous situation that
could lead to death, serious injury, or property damage.
Be sure to properly install, operate, and maintain the trolley so that it does not come off the beam.
Do Not lift more than the rated load.
Do Not lift people or lift loads over people.
Do Not operate with side or off center loading of load.
Do Not operate a damaged or malfunctioning product.
Do Not remove, deface, or obscure warning labels.
Do Not leave a suspended load unattended, unless specific precautions are instituted.
Do Not operate until personnel are warned of approaching loads and are cleared from the area.
Do Not operate if locking nuts are not tight and locked in position.
Do Not operate if space washers are not correctly spaced (refer to inspection chart).
Do Not operate if end stops are defective and don’t restrain the trolley.