VariZoom VZPROLITE - Manual (Page 2)

Page 2
For ProLites Equipped with Optional Battery Mounts
If you ordered your ProLite with one of the optional battery
mounts (Anton Bauer, NP1, V-lock), your kit will not include
the battery and charger. You must supply your own battery
system in this case.
Subsystems
The Vest
The purpose of the vest is to comfortably distribute the
weight of the camera and stabilizing system on your body.
To achieve optimal results, you
should adjust the vest so that it
fits snugly.
Adjust the vertical fit by
adjusting the straps, pulling the
chrome release pin and sliding
the chest plate up or down until
you find the right position.
Adjust the tightness of the vest
around your waist using the
Velcro strap, drawing it around
evenly on both sides of the
lower vest pad.
Adjust the tightness around
your torso by positioning the
Velcro straps across the back of the vest and securing the
buckles to the chest plate. Make the vest as tight as
possible to maximize operational quality and comfort. Once
you’ve adjusted the vest, remove it for easy re-suiting by
unclipping the buckles and strap on one side only.
Page 11
Low Mode Assembly
The Low Mode kit (optional) consists of the camera cage,
the sled-to-arm tie rod, and a few screws. Start by attaching
the dovetail plate, upside-down, to the top of the camera
cage using the supplied screws (the top of the cage has
threaded holes). Then turn the sled upside-down and slide
the dovetail plate into the stage. Mount the camera inside
the cage using the supplied screw. Connect the sled to the
arm using the tie rod; the gimbal handle should fit into the
round hole on the oval shaped end of the tie rod and the
squared end should slide over the post on the spring arm.
The stage knobs and multiple cage holes allow for
horizontal balance adjustment, and you can adjust the
vertical balance using the same adjustments as in normal
upright mode.
Camera cage may differ
slightly from those pictured