VariZoom STEALTHYPRO - Manual (Page 6)

screw is not loose.
(Note: You should never unlock the gimbal when the bottom of handle is
engaged. If you do the handle will turn and can cause damage to device if operator
continuously turns handle while engaged.)
6. Camera plate: The camera plate is slid into and removed from the captive re-
ceiving platform. The camera plate is very low profile and has a threaded bolt that is
used for attaching to your camera. Simply use a coin to tighten bolt in to your cam-
era to fasten the two together. The position of your camera on plate depends on
your preference when using in the different modes.
7. Camera platform: That platform has two adjustments that affect the camera
plate. One is a winged stainless steel bolt that is for tightening the plate in place the
other is the release button on side that must be pushed to release plate once the
winged bolt is loosened.
8. Tilting Head Platform: There are two adjustments on the platform one is for ad-
justing the right and left positioning of camera for camera balance (stabilization) the
other is a cam lever for locking the position of the entire tilting platform assembly we
refer to as the “head”.
9. Short Monopod: In the monopod / stabilizer mode there is a telescoping pod
that may be removed, loosened and or tightened by turning the base monopod to
the right to tighten and to the left to loosen and or remove. If you were to remove
the monopod you would see an expanding part that by friction catches the sides
of outer tube to loosen and tighten. This monopod has several purposes including
adjusting height in monopod mode adjust balancing weight in stabilizer mode and
setting the distance of camera from operator in the 3-point shooter mode.