Audica MICRO plus - Manual (Page 8)

Normal Mode (per channel):
Programme power output: 80W into 4 , 40W into 8
Sine wave r.m.s. power output: 55W into 4 , 28W into 8 (restricted by limiter operation)
Peak power output: 160W into 4 , 80W into 8
Gain: -infinity to 28dB (adjustable on rear panel)
Frequency Response: <10Hz to 35kHz (-3dB), less than 1dB down @ 20kHz
Signal to Noise ratio: 86dB (22Hz to 22kHz), 90dB (A-weighted)
THD: <0.03% (at 1kHz and 25W), <1% (20Hz-20kHz) all output levels
Input level for 55W output: 610mV r.m.s. at maximum gain setting (limiter operation begins)
Input impedance: 10k
Maximum input level: 30V r.m.s.
Ohm Ohm
Ohm Ohm
Ohm Ohm
Ohm
Bridge Mode (per pair of channels):
Programme power output: 160W into 8
Sine wave r.m.s. power output: 110W into 8 (restricted by limiter operation)
Peak power output: 320W into 8
Gain: -infinity to 34dB (adjustable on rear panel)
Frequency Response: <10Hz to 35kHz (-3dB), less than 1dB down @ 20kHz
Signal to Noise ratio: 86dB (22Hz to 22kHz), 90dB (A-weighted)
THD: <0.03% (at 1kHz and 50W), <1% (20Hz-20kHz) all output levels
Input level for 110W output: 610mV r.m.s. at maximum gain setting (limiter operation begins)
Input impedance: 10k
Maximum input level: 30V r.m.s.
Ohm
Ohm
Ohm
Ohm
Protection:
Over-current (low impedance loads), short-circuit, over-temperature, input overload, anti-clipping limiter.
Display:
LED bargraph showing input level, -18dB, -12dB, -6dB, -3dB, 0dB.
0dB indicates limiter activation.
Mains input:
Voltage: 100-120Va.c. or 220-240Va.c. (switch on rear)
Frequency: 50 or 60Hz
Idle power consumption: 27W
Typical operating power: 100W (Music signal at high level - limiter operating)
Maximum input power: 350W (Full power sine wave on all channels)
Cooling:
Passively cooled by convection. Air enters at sides and exits through top of case.
Please allow at least 7cm of clearance above top of case and 4cm each side.
Specification