AEG LAVAMAT 72630 - Manual (Page 26)

Operating Instructions
26
Washing Cycle Ended/Remove Washing
After a washing program has ended, END lights up on the program se-
quence display.
If you selected RINSE HOLD, the indicator next to the button START/
PAUSE flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
– Either press the button START/PAUSE
(water is pumped off and the washing is spun according to the
program which has just run; after the button START/PAUSE is pressed
again, the spin speed can also still be changed during spinning),
or
– turn the program selector to OFF and then to PUMP OUT and press
the button START/PAUSE
(water is pumped off without spinning),
or
– turn the program selector to OFF and then to SPIN or SHORT SPIN
and press the button START/PAUSE
(water is pumped off and the washing is spun or gently spun).
The indicator END lights up after the end of this program step.
2. Open the filling door.
The filling door can be opened as soon as the indicator DOOR lights up
green.
3. Remove the washing.
4. Turn the program selector to OFF.
5. Close the water valve.
6. After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
3 If the display OVER DOSING lights up, too much
washing detergent was used in the washing program
just ended. During the next wash, pay attention to
the dosing information of the washing detergent
manufacturer and pay attention to the filling quantity!
Important! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.