HighPoint RocketStor 5422 - Manual (Page 6)

6
SATA Drives Installation and Ejecting
The RocketStor 5422 supports 1 or 2 disk configurations of 2.5” and 3.5”
SATA storage devices of any performance level and capacity.
Installing a Device - Carefully align the SATA device’s gold fingers with
the bay’s SATA connector. Gently push the device straight down until
secure.
Ejecting a Device - Hold the
base of the RocketStor device
and press the Eject Button.
Gently remove the drive by
pulling straight upwards.
Note: The surface temperature
of some 3.5" hard disks may exceed 50 degrees C after extended use -
approach with caution. Carefully assess the surface temperature of
any hard disk before removal. If you suspect the temperature is too
high, please power down the target drive using the bay's
independent power button. Allow the drive to cool for several
minutes before removal.
Using the SMART Clone Software
HighPoint's revolutionary SMART Clone Storage Software Solution
transforms any RocketStor 5422 Storage Dock into a powerful
all-purpose backup and disk cloning solution!
SMART Clone can