Avalon Acoustics Symbol - Manual (Page 7)

7
3 Wiring Instructions
Introduction
The crossover is contained in a non-accessible chamber in the bottom of the speaker
cabinet. The SYMBOL is equipped with high-quality barrier terminals for connecting the
speaker cables. Ring terminals or spade lugs designed for #10 screws are recommended
for cable termination.
Connecting the Speaker to the Amplifier
1. Place the speaker in its approximate location, then lay the speaker on its side, using a
soft surface to avoid scratching the finish.
2. Connect the speaker wires to the terminal block on the speaker bottom (see Figure
3.1). Check to insure the correct polarity (positive lead connected to the (+) terminal
and negative lead connected to the (-) terminal.
3. Stand the speakers up.
Figure 3.1 - Bottom view of the speakers showing the
connections from the amplifier to the loudspeaker. Check to
insure the correct polarity (positive lead connected to the (+)
terminal and negative lead connected to the (-) terminal.
From Amplifier
Do NOT overtighten the screws.