X Rockers 51259 - Manual (Page 4)

Always make sure hinge is locked before moving unit.
Always make sure hinge is locked before sitting in the X Rocker.
Excessive use of audio equipment could lead to hearing loss.
Children under the age of 13 should not use this product without adult supervision.
Strictly for indoor use-do not expose to direct sunlight, moisture or extreme temperatures.
If cover becomes wet disconnect power immediately and don't use until completely dry.
Never try to remove cover or any components to avoid injury or death from electrical shock.
Foldable construction for ease of storage and portability.
Side control panel with volume, bass control, Vibration control and input/output jacks .
Ergonomic design with full back support.
Hardwood frame construction with dual layer foam cover for extra comfort.
Easy to clean, heavy duty, upholstery grade vinyl cover.
PICTURE OUT OF BOX
POSITIONING FOR SECURING
PIN AND VELCRO FLAP
SITTING POSITION
SET UP :
1. Lift X Rocker out of box by opening the top and turning the box over. DO NOT LET THE UNIT FALL OUT. Slide the box off
of the unit. Do not grab sides of X Rocker as that may lead to accidental speaker damage.
2. Keep the chair in the folded position and place it on the floor so that back side of the chair is touching the floor and
the bottom of the seat is facing up.
3. Insert pin into closure. Pull and secure the Velcro flap to hide pin and closure.
4. Review the set up diagrams to familiarize yourself with the X Rocker's components, accessories, and set-up.
5. Carefully turn chair over.
6. Locate the input/output panel at the front of the seat. When used in wired mode, make sure that the control panel is
not more than 9.84ft/3 meters away from the audio and 6.56ft/ 2 meters away from power.
7. Unpack the power adapter and connect it to the main power outlet, then to the power jack on the control panel. (A7)
8. Press the power button and confirm that the power indicator light (A1) is on.
9. Follow the connection diagrams. They show how to connect the X Rocker to the audio source of your choice .
10. Adjust the bass and volume and vibration levels to your preference---start rocking.
READ BEFORE USAGE:
FUNCTIONS:
Arm assembly
1. Remove arms and arm brackets from box.
2. Locate the accessory pack containing bolts and Allen wrench.
3. Place the arm bracket on the right side. Put 2 bolts into the bracket and use the pre-drilled screw holes to fasten it in place.
4. Place the arm and hardware onto the bracket as shown in second diagram. Tightening all the bolts with Allen wrench.
5. Place plastic caps into the bolts holes. Push to fasten. Using the same method to assemble the other side .
WARNING
DO NOT USE ARMS TO
EXIT THE CHAIR. DO
NOT USE ARMS TO
MOVE OR LIFT THE
CHAIR.
THEY ARE FOR GAMING
SUPPORT ONLY.
For service: (866) 969-2603 For accessories and information visit: Xfunctional.com