Outback Power Systems FW-IOB-Q-120VAC Input/Output/Bypass Assembly - Installation Instructions - Manual (Page 7)

To install the FW-IOB-Q-120VAC:
• Remove the appropriate quantity of breaker knockouts from the breaker bracket.
• Pull the yellow tabs out from each breaker.
• Install the breakers on the din rail to approximately match the openings in the breaker bracket.
• Hold the breaker bracket loosely against the breakers on the din rail; move the breakers as
needed so they line up with the openings in the breaker bracket.
• With the breakers positioned properly, lock the yellow tabs to secure the breakers to the din rail.
• Install the AC Breaker Bypass Slide Plate (see Figure 5).
Installing the FW-IOB-Q-120VAC
Figure 4: AC Breaker Installation for FW-IOB-Q-120VAC
Bypass Breakers Output Breakers Input Breakers
(installed upside down)