Outback Power Systems PSX-240-Relay Installation Manual - Manual (Page 2)

Outback Power PSX-240-Relay User’s Guide
PSX-240-Relay User’s Guide Page 2
P/N: 900-0053-1
Rev. A – Released 12/19/2005
Introduction
Congratulations on your purchase of the PSX-240-Relay
Autotransformer with Auto-Disconnect from OutBack Power
Systems. This booklet contains important safety and user
instructions for the PSX-240-Relay that shall be followed
during its installation and maintenance. Please read the entire
booklet and all cautionary warnings on the PSX-240-Relay
carefully before installing the device.
PLEASE SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY GUIDELINES
Working with or around electrical components requires care and special
attention during installations. Shock, burns, equipment damage, fire and
even death can result from mishandling or incorrectly installing
electrical equipment. Please be aware of the following precautions:
• Installation must be performed by a licensed installer familiar
with local and national wiring codes. All installations must
comply with these codes as well as codes for structural
installation.
• All of the AC wiring to the circuit breaker terminals and the
neutral bus bar must be torqued according to the torque specs in
the MECHANICAL INSTALLATION section of this manual.
• Wiring to circuit breaker terminals must meet requirements of
the National Electric Code (NEC).
NOTE: The circuit breaker terminals will accept up to 10 AWG
wire. Use copper conductors only with insulation rated for at
least 75˚ C. See the WIRING CONNECTIONS AND TORQUE
SPECS section of this manual for more information.
Outback Power PSX-240-Relay User’s Guide
PSX-240-Relay User’s Guide Page 15
P/N: 900-0053-1
Rev. A – Released 12/19/2005
REGISTRATION
Your purchase of an OutBack Power Systems product is an important
investment. Registering your products will help us maintain the standard of
excellence you expect from us in terms of performance, quality and reliability.
Please take a moment to register and provide us with some important
information.
Name: __________________________________________
Address: ________________________________________
City, State, Zip Code, Country:
________________________________________________
Telephone Number: _______________________________
E-Mail: _________________________________________
Sold by: ________________________________________
Installer: ________________________________________
Purchase Date: ___________________________________
Model Number: ___________________________________
Serial Number: ___________________________________
Circle all that apply:
Off-Grid Installation Residential Installation
North America Location Utility Connected Installation
Commercial Installation Other ____________________
Mail to: Attn: Warranty Registration
Outback Power Systems
19009 62
nd Ave. NE
Arlington, WA 98223