Outback Power Systems FX Series Circuit Board Replacement Instruction - Manual (Page 5)

Installation & Programming Manual FX Circuit Board Replacement Copyright 2003  OutBack Power Systems, Inc.
900-0042-1 19009 62 nd Ave NE, Arlington WA 98223 USA
Page 5
Rev 2.0 10/26/04 Tel 360 435 6030 Fax 360 435 6019
STEP 7:
Now you get to remove the boards you want to replace.
CONTROL BOARD:
Lift up on the AC assembly as shown in Figure 6 until you start pulling on
the white and black AC output wires (located near the bottom of the AC
assembly). You will have just enough room to sneak the control board out.
Figure 6
AC ASSEMBLY:
Figure 7 shows the AC output wires. They must be disconnected to remove
the AC assembly. The white Neutral wire is on the bottom and the black Hot
wire is above it. Disconnect them by pulling them directly out from the
board. It may help to keep the AC Assembly in the slot and using needle
nose pliers when unplugging these tight wires.
Figure 7
AC Output Hot!
AC Output Neutral
Spiky Looking
Things