Arcam FMJ CD17 - Manual (Page 7)

e-7
english
advanced features
inFo (information)
Press info on the remote control once to display the
remaining time of the currently playing track. Press
again to display the time remaining on the disc. Press a
third time to turn the text display on.
Press
info again and the display reverts to its original
setting, showing the time elapsed for the current track.
For CDs with text, pressing
info once while the disc is
loaded but not playing displays the artist’s name.
Pressing
info a second time displays the total number of
tracks and the total playing time.
RPT (Repeat)
To repeat the entire disc or a pre-programmed selection
of tracks press rpt on the remote control once: ‘REPEAT’
lights on the display.
To repeat a particular track, select that track and then
press rpt twice so that ‘REPEAT 1’ is shown on the
display. If you now select a different track, that track is
repeated instead.
To cancel the repeat function press
rpt a third time.
PRog (Program)
The function allows up to 24 tracks from an audio disc
can be programmed to play in any order.
Select a track by using the
/ and 0 buttons, then press
prog on the remote control to program the track into
memory. ‘PROGRAM’ appears on the display to indicate
that you have started programming a sequence.
Repeat these steps to program the remaining tracks in
your selection. Alternatively, press prog on the remote
control once and enter your track selection using the
0–9 keypad.
The display shows the track numbers programmed,
the total length of the programmed sequence and the
number of tracks programmed (shown by a number
below the word ‘ STEP ’).
Each time you enter a track, the number below ‘ STEP ’
increments by one and flashes until you press prog
to confirm. If you fail to press prog within about five
seconds the display stops flashing and you will have to
reselect the track.
Press
4 to play the program. Press 4 again to replay the
entire sequence from the start. Press prog again to exit
the program facility: the display flashes ‘CONTINUE’ and
shows ‘0’.
a–b
This button on the remote control enables you to repeat
any section of music within a track. While a disc is
playing, press the a–b button at the start of the section
you wish to repeat. ‘REPEAT’ is shown on the display
and the letter ‘ A– ’ flashes.
Press the button a second time when you reach the end
of the section you wish to repeat. The ‘ A–B ’ letters stop
flashing and remain lit.
The selected loop repeats until you press
< or / or 0
to terminate. The forward search button ( 8 ) moves
forward only within the selected loop.