Se.s, Operation guide – American DJ FC 400 User Manual

Page 11

2.1.6 Scene Mode

2.2 Scene Channel Dimmer Mode

2.4 Stand By

2. Operation Guide

Press the Mode pedal several times until the
4-digit Segment Display shows

In Scene mode, press Up/Down pedal to select
the scene.

Press and hold down the Mode pedal 3 seconds
until the 4-digit Segment Display shows

Press Up/Down pedal to adjust the intensity of
channel 1 for the current scene. Once the intensity
is set, press Mode pedal to select channel 2, then
adjust the intensity for the channel. 00 will give the
lowest intensity, and FF will give full intensity.

Repeat the above steps until all four channels
are set. Press and hold down the Mode pedal 3
seconds to deactivate this mode.

SE.S

2.5.1 MIDI Channel Setting

2.5.2 MIDI Implementation

2.5 MIDI Operation

Press the Mode and Stand By pedals at a time,
the 4-digit Segment Display shows

Press Up/Down pedal to select the MIDI channel
within 01-16.
Press the Mode pedal to leave this mode.

This unit will send and receive Note On and Note Off data according
to the following table:

2.3 Full On

Press the Full On pedal, all channel LEDs will be fully on, all channel
will be full output. Release this pedal deactivates this function and
return to normal mode.

Press and hold down the Full On pedal 2 seconds, scene 11 is activated.
Press this pedal again to leave this scene and return to normal mode.

Press the Stand By pedal, the Stand By LED will flash, all channel will
be zero output. Press this pedal again to leave mode and return to
normal mode.

Press and hold down this pedal 2 seconds, scene 12 is activated.
Press this pedal again to leave this scene and return to normal mode.

Note Number

Function

Mode pedal

Up pedal

Down pedal

Full On pedal

Stand By pedal