American Audio DCD-PRO300 - Manual (Page 10)

13. REPEAT PLAYBACK
1) Press REPEAT button, the REPEAT 1 indicator lights , the player repeats the one track selected.
2) Press REPEAT button again, the REPEAT ALL indicator lights . The player will then repeat all tracks on disc.
3) Press REPEAT button again, the repeat function is cancelled.
14. PITCH BENDING
• The speed increases or decreases respectively wh ile the PITCH BEND+(9) or PITCH BEND- button is
pressed. The extent to which the speed changes is proportionate to the amount of time the button is pressed.
For example, if the PITCH BEND+ button is held in continuously, the speed increases continuously.
• The pitch changed within a range of +/- 16% .
• The jog wheel will temporarily bend the pitch of the music if the song is already playing by r otat ing the wheel clockwise to
speed up or counterclockwise to slow down. The speed that you rotate the JOG WHEEL determines the percentage
of the PITCH BEND.
15. PROGRAM PLAY
Press the PROG. BUTTON to make the unit enter the program mode and stop condition .
The program indicator light . Select Track using NUMBER button press PROG. again.
Repeat this up to 30 times.
Press the PLAY BUTTON to begin playing programmed tracks.
To cancel Program press and hold PROG. BUTTON more than 2 seconds.
(1) Find the BPM of the song playing by pressing the BPM BUTTON . Then tap COUNTER BUTTON (18) firmly to the beat of the
music until BPM is displayed on the LCD
(2) Repeat step 1 for the song you want to mix in. You can listen in by cueing it in your headphones using your mixer or by follow
the BEAT LED on the CD .
(3) Engage Pitch by pressing PITCH on the side you want to use, make sure Readout is in BPM by pressing BPM BUTTON until
BPM is lit on LCD . Adjust pitch until same BPM as original song is reached.
MATCHING THE BEATS PER MINUTE (BPM)
BASIC OPERATIONS (CONT.)
11. LOOP PLAY
You can loop between two points continuously.
Press IN REAL TIME CUE Button for starting point
Set end point by pressing OUT/EZIT Button, CD will begin looping until OUT/EXIT Buttonis pressed again.
Press Reloop to again enter the loop.
NOTE: this is not a seamless function.
12. TIME DISPLAY
During normal play, each time you press TIME button, the display changes to give you the following information
(Fig.14)
A = ELAPSED playing time .
B = REMAINing time in a selection. If the current selection number is over 34, “...................” is displayed.
C = TOTAL remaining time of the disc .
American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 10