beautypg.com

Atek electronic Stagehand RM200 User Manual

Page 8

background image

Stagehand User’s Manual, page 7

• After your laptop or desktop computer is powered on and fully booted up, plug the

Stagehand USB receiver into the computer’s USB port.

A solid color LED on the USB receiver indicates the receiver has power from the

computer. The LED flashes when it receives keyboard command signals from the

remote control, but do not push any buttons on the remote control yet.

Do NOT push the button on the receiver (the remote control and receiver are already

preset in the factory to communicate with each other).

Wait until the pop-up message on your computer screen says that the installation is

complete and the device is ready to use before using the remote control.

• Optionally install the enclosed neck lanyard per the separate safety warning and

installation instructions that come with the lanyard.

Remember to turn the remote control off after use to extend battery life and prevent

accidental battery drain.

Read the Operation section below for detailed instructions on how to use your

Stagehand.

Installation