Yetter 2967-097 TITAN Series Short U.N.T. CNH Residue Manager User Manual

Page 15

MAINTENANCE

Lubrication Symbols

Lubricate with grease at hourly interval indicated on symbol.

Lubrication Intervals

IMPORTANT: The recommended service intervals are based on normal conditions;

severe or unusual conditions may require more frequent lubrication.

Perform each lubrication and service procedure at the beginning and end of each

season.

Clean grease fittings before using grease gun, to avoid injecting dirt and grit into the

bearing. Replace any lost or broken fittings immediately. If a fitting fails to take grease,
remove and clean thoroughly, replace fitting if necessary. Also check for failure of adjoining
parts.

BEARING REPLACEMENT INSTALLATION

1. When assembling the spoke wheels, bearing assembly and hubcap, be sure to align

the grease transfer hole in the spoke wheel with the groove in the hubcap and hole in
the hub to allow grease passage.

2. Assemble the wheels, hubs and caps.

3. Grease the wheel/hub/bearing assembly.

This manual is related to the following products:

2967-029 TITAN Series Short U.N.T. CNH Residue Manager