Yetter 2920-020 Sealer Wheels W/2920-212 Bracket - Manual (Page 2)

1. Attach Shank Mounting Bracket W.A. (#2) and shank mounting clamp plate
(#3) to shank with two 1/2 x 3 bolts and lock nuts.
2. Attach the Mounting Bracket W.A. (#8) to the shank mounting bracket with
two 1/2 x 1-3/4 bolts and lock nuts.
3. Insert the inner pivot bushing (#6) through the pivot collar of the mounting
bracket.
4. Insert the push rod between the side plates of the mounting bracket and
secure with a 5/8 x 2-1/2” bolt and jam nut.
5. Attach the sealer wheel arm W.A. (#18) to the mounting bracket with a 1/2 X
4-1/2” bolt and hex nut.
6. Slide the spring bracket (#15), spring (#14), spring bushing (#13) and 3/4”
lock nut on the push rod. Tighten the nut down until about 1/4” of threads are
exposed.
7. Attach the 4.5” x 16” gauge wheels (#21) to the adjustment stem (#23) with a
5/8 x 4” bolt, ¾” spacer, lockwasher and 5/8” nut.
8. Slide gauge wheel assembly into the sealer wheel arm and secure with pin
(#17).
2565-458 01/09