Yetter 2000 Series AllSteer Plus Fertilizer Toolbar - Manual (Page 20)

20
1
Hydraulic Hook Up
DANGER:
Inspect and replace worn or frayed hydraulic hose. Keep all connections tight,
escaping hydraulic fluid under pressure can have sufficient force to penetrate the skin and cause
serious personal injury. Fluid escaping from a small hole can be almost invisible. Use a piece of
cardboard or wood rather than hands to search for suspected leaks. Failure to heed may result in
personal injury or death.
The Yetter All Steer Plus ™ Fertilizer Toolbar requires two remote hydraulic valves on the tractor for proper
operation. Before operating in the field, perform the following steps.
1. Connect the All Steer Plus ™ Fertilizer Toolbar to the tractor drawbar before operating the cart hydraulic
system. Check the tractor hydraulic system fluid level. Filling all four cylinders with fluid will require
approximately 3-4 gallons. DO NOT operate tractor hydraulics when fluid level is too low.
2. Connect the hoses from the All Steer Plus ™ Fertilizer Toolbar to the tractor. The hydraulic hoses are
provided with the adapter attached. Use ¾-16” standard thread quick coupler tips.
3. Hold hydraulic lever in extend position for 15 seconds after cylinders are fully extended to purge air from
the system.
4. Recheck tractor fluid level and refill if necessary.
5. Cycle cylinders back and forth a couple of times to see that they operate together. Hold the lever in the
extended position a few seconds after each cycle for additional air purging.
NOTES: