Tuff Country 43800 - Jeep Cherokee 87-01 3.5 kitt - Manual (Page 3)

Special note: Before installation begins, it is the
customers/installers responsibility to make sure that all
parts are on hand. If any parts are missing, please feel
free to call one of our customer service representatives
@ (801) 280-2777.
Hardware bag 12NW includes:
Description Quantity
SUW-12 (1/2” u-bolt washer) 8
12HN (1/2” u-bolt high nut) 8
Hardware bag 43800PL includes:
Description Quantity
MO2617 (poly bushing) 8
S10209 (sert fitting) 4
Hardware bag 43800NB includes:
Description Quantity
M1050B (10 mm x 50 mm bolt) 4
M1070B (10 mm x 70 mm bolt) 1
M10UN (10 mm unitorque nut) 1
14WA (1/4” USS flat washer) 6
5161B (5/16” x 1” bolt) 3
516UN (5/16” unitorque nut) 3
516WA (5/16” USS flat washer) 4
381B (3/8” x 1” bolt) 1
38UN (3/8” unitorque nut) 1
38LWA (3/8 lock washer) 4
38SAE (3/8” SAE washer) 4
Hardware bag 43800NB1 includes:
Description Quantity
BLR02 (front brake line bracket) 2
BLR03 (rear brake line bracket) 1
BLR05 (front brake line bracket) 2
BP07 (clevis mount) 2
BP20 (clevis mount) 2
LUBE (poly lube pack) 2
Hardware bag 43800SL includes:
Description Quantity
S10041 (.815” x .563” x 2.800”) 4
S10048 (.620” x .500” x 1.250”) 1
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:__________________________________
Passenger side rear:______________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:_________________________________
Passenger side rear:______________________________
Front end installation:
1. To begin installation, safely lift the front and rear of the
vehicle and support the vehicle with jack stands on each cor-
ner of the vehicle. Next, remove the front wheels and tires
from both sides.
2. Working on the driver side, remove the stock shock from
the upper and lower mounting location. Save the lower
mounting hardware. The upper mounting hardware and
shock may be discarded. Repeat procedure on the passen-
ger side. Special note: New longer front shocks are
needed after this suspension system has been installed
and the front shocks need to be ordered as a separate
part #. If you have not already ordered your front
shocks, please feel free to contact Tuff Country or your
local Tuff Country dealer and order your front shocks.
Tuff Country recommends installing a 23” fully extended
cellular shock in the front.