Tuff Country 30991 - Dodge Ram Performance Traction Bars - Manual (Page 3)

All the pictures in this installation are on the driver side!
Please follow instructions carefully:
1. To begin installation, block the front tires of the vehicle so
that the vehicle is stable and can’t roll forward. Safely lift the
rear of the vehicle and support the vehicle with a pair of jack
stands. Place a jack stand on both the driver and the pas-
senger side.
2. Working on the driver side, remove and save the nut from
the bolt that connects the spring into the spring hanger.
Repeat procedure on passenger side.
3. Locate the new driver and passenger side front traction
bar bracket. Working on the driver side, install the new front
bracket over the OE spring hanger and secure using the OE
nut. Make sure to use loctite and torque to 110 ft lbs.
Repeat procedure on the passenger side.
4. Working on the driver side and using the newly installed
front traction bar bracket as a guide, carefully drill 3 holes
into the OE hanger. Repeat procedure on the passenger
side.
5. Locate (6) 3/8” x 1” bolts, (6) 3/8” unitorque nuts and (12)
5/16” USS flat washers from hardware bag 30991NB.
Working on the driver side, install the new 3/8” hardware to
the previously drilled holes. Make sure to use loctite and
torque to 28 ft lbs. Repeat procedure on the passenger
side.