Tuff Country 23000 - Ford 09-13 F150 3 lift kit - Manual (Page 3)

Hardware bag 23000NB includes:
Description Quantity
S10236 (.750” x .563” x 2.400” sleeve) 4
PB69127 (poly bushing) 8
SERT04 (sert fitting) 4
Hardware bag 916NW includes:
Description Quantity
916HN (9/16” u-bolt high nut) 8
SUW-916 (9/16” u-bolt washer) 8
Hardware bag D2P-NB includes:
Description Quantity
38NLN (3/8” nylon nut) 6
516WA (5/16” USS flat washer) 6
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:__________________________________
Passenger side rear:______________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:_________________________________
Passenger side rear:______________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle so
that the vehicle is stable and can’t roll backwards. Safely lift
the front of the vehicle and support the vehicle with a pair of
jack stands. Place a jack stand on both the driver and the
passenger side. Next, remove the front wheels and tires
from both sides.
2. Remove the wire harness from the rack and pinion and let
hang.
3. Working on the driver side, remove the hardware con-
necting the sway bar to the sway bar end link. Save the hard-
ware. Repeat procedure on the passenger side.
4. Working on the driver side, remove the brake line bracket
from the knuckle. Save the hardware. Repeat procedure on
the passenger side.