AT&T 952 - Manual (Page 6)

Automatic Redial
This phone can automatically and repeatedly redial
the last number you called. Press
L or l, then
press
a without lifting the handset or
pressing K or h. You will hear the
numbers being dialed. When the call is answered, you
must either lift the handset or press
K or
h to talk.
If the line called is busy, the phone will redial every
40 seconds up to 10 times (timing begins when the
phone is on hook).
To stop automatic redialing at any time, press
a again. Lifting the handset or pressing
K or h will also cancel Automatic Redial.
NOTE: This feature will not work if C is
pressed. This feature works when the handset is
on hook.
Switching Between Lines During a Call
During a call on one line, you can make or answer a
call on the other line by pressing
H. You can use
the
H and LINE buttons to switch back and forth
between calls as often as necessary.
Example: While using Line 1, Line 2 rings:
1 Press
H to hold Line 1.
2 Press
l to answer the other call.
3 Press
L to hang up Line 2 and return
to your first call
— OR —
Press
H to hold Line 2, and press L
to return to your first call.
Conference Calls
You can use both lines at the same time to set up
a three-way conference call.
1 Make or answer a call and press
H.
2 Establish a call on the other line.
3 Press C.
4 Hang up to end a conference call.
If one caller hangs up during a conference call, you
might hear a dial tone. Press the LINE button of the
remaining call to disconnect the other line and
eliminate the dial tone.
NOTE: Under certain circumstances, the far-end
parties on a conference call may not hear one
another clearly.
Conference Call Options
To place a conference call on Hold:
1 Press H to hold both lines.
2 Press C to release Hold then lift the
handset or press K or h and
continue your conference call.
To talk privately with one caller:
1 Press the LINE button of the person with
whom you want to speak privately then lift
the handset or press
K or h.
2 Press C to continue your conference
call.
To disconnect one party from a conference call and
keep the other on the line, press the LINE button of
the call you want to continue.
NOTE: If you leave the C button down after
a conference call, then dial another number, your
call might be completed, but you might hear a busy
signal from the other line. Press
H, then press
each LINE button until you identify the line being
used for your completed call.
T E L E P H O N E O P E R A T I O N
6