Tuff Country 13090 - GM 11-13 Silverado 3500HD 3.5 lift kit - Manual (Page 10)

40. Carefully remove the (2) hydraulic floor jacks from under
the rear differential.
41. Check and double check and check again to make sure
all steps have been performed properly with the rear end.
42. Install the tires and wheels and carefully lower the vehi-
cle to the ground.
43 Move back to the front of the vehicle and working on the
driver side, adjust the torsion bar adjusting bolt until your
measurement from the lip of the front bump stop to the bump
stop landing on the lower control arm reaches 4 1/2”. Repeat
procedure on the passenger side.
Congratulations, installation complete!
Special note: After the completion of the installation, Tuff
Country EZ-Ride Suspension recommends taking the
vehicle to an alignment shop and having a proper front
end alignment performed.
Tuff Country EZ-Ride Suspension recommends that a
complete re-torque is done on all bolts associated with
this suspension system. It is the customers responsibil-
ity to make sure that a re-torque is performed on all hard-
ware associated with this suspension system after the
first 100 miles of installation. It is also the customers
responsibility to do a complete re-torque after every 3000
miles or after every off road use. Neglect of following
these steps could cause brackets to come loose and
cause serious damage to the suspension system and to
the vehicle.
Tuff Country EZ-Ride Suspension packages (2) sets of
instruction sheets with this box kit. (1) is for the installer
and (1) is for the customer. The (1) for the customer has
some post installation procedure literature and it is the
installers responsibility to make sure that the customer
receives a copy of the installation manual along with the
literature.
If you have any questions or concerns, please feel free to
contact Tuff Country or your local Tuff Country dealer.