beautypg.com

Important, Programming a preset – Alto-Shaam Cook & Hold Oven Electronic Control 1000-TH/III User Manual

Page 22

background image

pg

. 20

TH/III

InsTallaTIon

/

operaTIon

/

servIce

manual

O p E R A T I O N

programming a preset

Select the product to be programmed and begin programming with the oven control power O

ff

.

press and release control O

n

/O

ff

key. The oven will beep for one second and power to the unit

will be indicated by an illuminated green indicator light located in the upper left corner of the

O

N

/O

ff

key. The oven will begin operating in the hold mode. The amber H

old

indicator will be

illuminated and the last set hold temperature will be displayed.

To set Cook temperature Press c

ook

Key. Oven preheat indicator will illuminate and the last

set cooking temperature is displayed. To change the cook temperature, press the u

p

or d

own

a

rrow

Keys.

if cooking by time press the t

ime

Key. The green t

ime

indicator will illuminate and the last set

cooking time will be displayed. To change the set time, press the u

p

or d

own

a

rrow

Key. The

display will alternate between the set temperature and the elapsed time.

if cooking by probe — press the

p

robe

Key. The green p

robe

indicator will illuminate and the last

set internal product temperature will be displayed. To change the set temperature, press the u

p

or d

own

a

rrow

Key. The display will alternate between the set temperature, the elapsed time,

and the probe temperature.

To set Hold temperature Press the h

old

Key. The green cook indicator light will remain

illuminated. To change the hold temperature, press the u

p

or d

own

a

rrow

Key. The display

will alternate between the set hold temperature and the amount of time the product has been in

the hold mode. Oven will remain in the h

old

mode until the o

N

/o

ff

key is pressed.

Select a letter code for the product programmed by the previous steps. Press and hold the selected

p

reset

key for two seconds. When the preset has been saved, you will hear a one second beep and the

preset light will illuminate.

note: Only one preset can be programmed at a time. If programming an additional preset is

desired, the unit must be started and stopped either by cycling the power to the cavity or by

pressing the S

tart

/S

top

key. The last p

reset

Key used will be the oven cooking run sequence

for the next product to be programmed. Settings can be manually changed for the next

product and an alternate pre-programmed letter key selected.

Erasing a preset

To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven

cannot be running a p

reset

Menu program.

When the oven is in the power-up hold mode or in the preheat mode, press and hold the c

ancel

Key and

then the appropriate letter p

reset

Key to be erased for two seconds. When the preset has been erased the

oven will beep for one second.

important -

after programming a specific product into memory in a programmable

preset key, it is very important to make a written permanent record of the product and the

program letter assigned. menu card (pE-23384) is provided for this purpose.