Storage, Service parts, Accessories – Ariens 939002 ST520 User Manual
Page 20
GB - 20
8. Replace attachment drive belt (See Replace
Attachment Drive Belt on page 18).
9. Check traction drive clutch adjustment. See
Traction Drive Clutch Adjustment on page 17.
SHORT TERM
IMPORTANT: NEVER spray unit with high pressure
water or store unit outdoors.
Run with attachment clutch engaged a few minutes
after each use to free unit of any loose or melting snow.
Inspect unit for visible signs of wear, breakage or
damage.
Keep all nuts, bolts and screws properly tightened and
know unit is in safe working condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low pressure
water and lubricate (see Maintenance). Touch up all
scratched painted surfaces.
Remove weight from wheels by putting blocks under
frame or axle.
When storing unit for extended periods of time, remove
all fuel from tank and carburetor (run dry). Refer to
Engine Manual.
STORAGE
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
SERVICE PARTS
Order the following parts through your Dealer:
Part No.
Description
00036800
Ariens Hi-Temp Grease (3, 3 oz.
cartridges)
21533400
Spark Plug (939001, 002)
07200108
Impeller Belt
07200109
Stretch Fit Traction Belt
53200500
Shear Bolts
ACCESSORIES
See your authorized Ariens dealer to add the
additional accessories available to your Sno-Thro.
Part No.
Description
73203100
Slicer Bar*
72200600
120 Volt Starter Kit
73202500
240 Volt Starter Kit*
72406500
Front Weight Kit*
*Available in CE countries.