Rubbermaid 9VWD16 - Manual (Page 9)

16 17
ENGLISH
Emptying Wet Tank
1
Disconnect power cord from outlet. Unscrew and remove drain cap.
Reinstall drain cap. (Vacuum cleaner is now ready for use.) Empty contents into suitable drain or container. Tilt vacuum
cleaner to allow any remaining liquid to drain.
2
1
2
3 4
2
1
Disconnect power cord from outlet.
Blower Mode Operation
When either tank is full of liquid, the
automatic shut-off mechanism will turn
off vacuum cleaner motor. The automatic
shut-off mechanism will also engage if the vacuum
cleaner has been tipped over. If tank(s) are full, turn
vacuum cleaner off and empty tank(s) to continue use.
If vacuum cleaner has been tipped over, turn vacuum
cleaner off and set upright. Wait a few seconds to
allow the motor to come to a complete
stop before turning back on.
Insert hose into blower inlet and turn clockwise to lock.
(Blower is now ready for use.)
1 2
1
2
U
Liquid Overflow Protection
1
Disconnect power cord from outlet.
Replacing HEPA Filter/
HEPA Foam Sleeve
2
2
1
A
Release latches. Remove powerhead. Turn powerhead upside down. Remove old HEPA filter/HEPA
foam sleeve.
3
1
2
3
Y
A
X
5
1
2
A
Reinstall powerhead. Fasten latches. (Vacuum cleaner is now
ready for use.)
2
1
4
3
Y
A
X
Slide new HEPA filter onto float cage, ensuring that it is fully
seated onto powerhead. Slide HEPA foam sleeve over HEPA
filter. Turn powerhead right side up.