Rubbermaid 750613 - Manual (Page 5)

Step 9
Mount the earth ground clamp (GG) to the cold water supply pipe.
Step 10
Connect the green earth ground wire (GG) to the earth ground clamp tab.
Step 11
See battery compartment installation instructions below. Then connect the battery power wires together.
Step 12
Test the black sensor wire (T) with your fingers. There will be a clicking sound coming from the valve control
module indicating that the faucet is installed properly. Then connect the black sensor wire (T) to the sensor
connection washer (N).
Step 13
Connect the supply hoses (W) to the valve stops. Turn on the hot and cold water supply and test faucet.
NOTE:
• If this is an AC adapter installation, skip “Battery Compartment Installation” and use instructions supplied with
the AC adapter.
Battery Compartment Installation
1. Remove battery compartment cover by unscrewing the two Phillips screws. Inside the battery compartment
(Z) there are two large screws and anchors (AA). Place the battery compartment (Z) in a convenient location
ensuring easy access.
2. Secure to wall using screws and anchors (AA) or double-sided tape (BB).
3. Install four (4) “D” cell alkaline batteries (DD). Replace cover on battery compartment. Connect battery box
connector to valve power connector. Once power is established, you will hear a clicking sound when you
place your hand under the faucet.
4. Turn water supply on. The water will automatically come on when you place your hand under the
faucet. The water will stay on for a maximum of 15 seconds as long as your hands are under the
faucet, and moving. The water will shut off after you remove your hands from the sensing zone or water
stream.
5. Verify water supply connections are not leaking.
Setting Water Temperature Mix
1. There is a temperature dial on the mixing valve (X). Use a screwdriver to loosen the screw on the dial.
(To add hot water, turn the knob to the right or to the left to add cold water.)
2. Once you have the desired water mix temperature, lock the control knob in place with a screwdriver.
3. There is a temperature adjustment on the optional thermostatic mixing valve (Y). Use an allen wrench to turn
adjustment screw to add hot or cold water.
5