Powerwinch 912 User Manual
Page 7
P
OWERWINCH
712
&
912
B
OAT
T
RAILER
W
INCH
5
P
ULLEY
B
LOCK
The pulley block can increase the pulling capacity approximately 55%.
Assembly Instructions:
1. Place the two screws through one of the tear drop plates
and hold in place.
2. Slide a bushing over each screw.
3. Slide the pulley wheel and hook over the bushings as
shown. The components fit loosely on the bushings.
4. Wrap the cable around the pulley.
5. Place the second tear drop plate over the screws and
secure using the washers and nuts provided.
6. Mount an eyebolt next to the winch. The eyebolt should be mounted as
close to the winch as possible. Eyebolt is furnished by the installer.
Bow
Eye
Eye Bolt
Pulley Block
Level
12” minimum
PW912002
Double Lining the Winch
1. With the cable threaded through the block, hook the pulley block to the eye
on the bow.
2.
Power out the cable and attach the cable hook to the eyebolt next to the winch.
3. Power in the cable.
pw915014