Powerwinch Quick Catch Pot Puller - Manual (Page 8)

C APSTAN P OWERED L IFT A SSIST P OWERWINCH
6
14. Route one R ED wire from the battery to the switch location. Be sure to
allow adequate wiring to make connections, allow the wire to have some
slack when routing. Secure the wires with wire ties.
15. At the switch terminate the new wire with a 5/16 ring terminal and attach to
the second short wire from the switch with a 1/4 -20 screw and nut and shrink
wrap.
16. At the battery terminate the R
ED
wire with a #10 ring terminal. Attach the wire to
the "AUX" post of the circuit breaker.
17. Attach the circuit breaker to the POSITIVE (+) terminal of the battery.
Black
Green
Black
*awg
Red * awg
Ring Terminals
1/4-20 x 1/2
Screw & Nut
Tape or
Heat Shrink
= Mechanical Connection
Red *awg
Circuit Breaker
Battery
pwcs005
Foot Switch
25A Circuit Breaker
(used w/ Capstan 300)
80A Circuit Breaker
(used w/ Capstan 1000 &
Quick Catch Pot Puller)
To Battery
(+12VDC)
Red
Wire
Ring
Terminal
Red
Wire
Ring
Terminal
To Battery (+12VDC)
* Use 8awg wire for Capstan 300
Use 6awg wire for Capstan 1000
Use 6awg wire for Quick Catch Pot Puller
T
ESTING THE
U
NIT
1. Ensure that all connections are secure and correct.
2. With no rope on capstan, press down the switch. If the motor runs but the
capstan does not turn, motor wires are reversed. Reverse the red and black
wires at the motor leads.