Poolmaster 72781 Classic Pro Poolside Basketball Game - Manual (Page 2)

A
ssembly I
nstr
uc
tions
2
Step 1
Thread Net on PVC Hoop.
This is the net right out of the package.
You will be working with the longer looped end.
This is a close-up of one loop.
Fold the loop toward you, creating two loops.
Insert your finger through the two loops.
Release the thumb holding the loop in place and pull
on the two middle strings. The loop should slide up
and catch your fingers.
Take the loop from your finger and slide onto the
basketball hoop. Continue this process with each
loop until all loops are on the hoop.
1
1
2
3
4
5
6
2 3
5 6 4
• Attach the Hoop to the Backboard by inserting
(2) 2 ½" Bolts through the Hoop Bracket, Hoop
and Backboard as pictured and secure with
Washers and Hex Nuts.
Step 4
Step 5
• Fill Base with water or sand and
cover up opening with Base Cap.
• Attach the PVC Backboard Support to
the Backboard using (1) 4 ½'' bolt
through the bottom hole of the
Backboard Hoop Bracket and into the
third hole from the bottom of the PVC
Backboard Support.
Step 6
• Use Ball Needle and a hand
pump(not included) to inflate.
poolmaster.com
(72781 only)
Step 3
• Insert the PVC Backboard Support into the Base
AT AN ANGLE. (Diagram A) While pushing Support
into the base, keep it pulled back a bit to make sure
that Support CLEARS the metal washer that is built
into the base at the opening (Diagram B). Use a
Rubber Mallet if necessary.
• Once the Support is inserted into the base, secure
through the 2nd hole from the bottom with (1) 2 ½”
bolt. (Diagram C)
Step 2
Backboard
Hoop
Bracket
2 ½"
Bolts x2
Base Cap
4 ½" Bolt
DIAGRAM A DIAGRAM B
DIAGRAM C
Washer
2 ½"
Bolt
Second
Hole
Down