Paragon 3060050 DEEP WELL CART - Manual (Page 4)

4
ASSEMBLY INSTRUCTIONS
SPOKE WHEEL CART
1. Attach Handle to the cart body using four 1/4” - 20 x 3/4” bolts, flat washers,
lock washers and hex nuts.
2. Turn assembly over on its top.
3. Install Long Legs to the same side of the cart body that the handle is
attached to using four ¼” – 20 x 2” Screws, flat washers, lock washers, and
hex nuts.
4. Press End Caps into the protruding end of legs.
5. Attach Cart Extension to the opposite side of the cart body that the handle is
attached to using four ¼” – 20 x 2” Screws, flat washers, lock washers, and
hex nuts.
6. Slide axle rod through the holes in the Cart Extension.
7. Slide a wheel over the axle rod on the outside of extension. Put a Clip Pin
through the holes on each end to secure the wheels to the axle.
8. Turn assembly the correct side up.
9. Position the stainless steel trays over the cart body and extension.
Note: Stainless steel covers come with protective vinyl coating. Simply peel
coating after assembly.