Paragon 9050 (240V) MIGHTYCORN DOG FRYER 3000 - Manual (Page 7)

7
Installation

Place the fryer on a suitable bench or table. Allow sufficient side space when using the
reversible top cover as a side tray. Position the fryer back enough from the bench top to
prevent the drain valve to not extend over the edge.

Check your local regulation codes. (Some localities may require an exhaust hood and/or
an approved fire extinguisher.

Mount the control panel assembly on to the tank. WARNING: Do not lift the fryer by the
control panel.

Secure the control panel by tightening the two thumb knobs located on the back side.

Plug the power cord into power outlet.

Do a start-up test to verify the unit is working:
1.
Turn on the control panel’s power switch

Momentarily depress the Reset (RST Button) to start the controller on start-
up
2. The digital temperature read out should indicate a temperature
3. Turn the temperature knob up to 200F
Warning: Turn temperature knob back to “Off” after a couple of seconds

Turn the power switch off

The heating element should be hot
4. Test is completed, the fryer is now ready for use
WARNING: Do not operate without any cooking oil.
Operation
1.
Be sure the “drain valve” is closed
2. Add approximately 37 lbs of cooking oil. Do not fill above the “MAX” line.
3. The fryer is now ready for use.
WARNING: Some products may require oil temperatures up to 375 ˚F. Use only trained
personal.
Cleaning

A fine mesh skimmer may be used to remove crust that forms during cooking periods or
during the routine clean-up

To drain the cooking oil, use the drain valve. An extension on the valve may be used to
direct the oil flow. To use the last remaining oil, block the back edge up slightly and also
a baster may be use.
WARNING: Do not drain until the oil is cooled down

With routine cleaning a fine grade steel wool may be used to remove the baked on oil
residue in the tank