MBRP S7263 - Manual (Page 2)

S7263 © 06/13 PAGE 2 OF 3
- Mustang GT . H-Pipe
Removal of Stock H-Pipe
1. It is not necessary to completely remove the cat back portion of the
exhaust to install this product. Loosen the OEM Band Clamps at the H pipe
outlets. Lift the lock tab and slide the extension pipes rearward to
disconnect from the OEM H pipe.
2. Loosen the OEM ball joint clamp located after the cats and remove the H
pipe from the car.
Refer to Figure 1.
3. Cut the retaining band that holds the clamp to the OEM H pipe. This
clamp will be reused.
Refer to Figure 2.
Installation of MBRP Inc. Performance Exhaust:
1. Reinstall the OEM band clamps over the outlets of each OEM cat pipe.
2. Assemble the Driver side H Pipe and the Passenger side H Pipe
on the floor. Be sure the expanded portion of the 2.25” Crossover Pipe
is on the driver side of the car and that the appropriate clamps have
been loosely installed.
Refer to Figure 3.
3. Install the H pipe assembly onto the car by aligning the ball joint
connections and then sliding the OEM band clamps over the connection.
Tighten the clamps just enough to hold the H pipe assembly in place but still
allowing for adjustment.
Refer to Figures 4 and 5.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5