MBRP S7244 - Manual (Page 3)

S7244 © 03/13 PAGE 3 OF 3
2. Install both Driver and Passenger Over Axle Pipes and insert them into
the Driver and Passenger Mufflers. Be sure that the supplied Clamps are
installed over the joint. Do not tighten yet.
Refer to Figure 6.
3. Install both Driver and Passenger Extension pipes by first installing the
OEM band clamp removed in Step 2 onto the inlet ends of the Extension
Pipes. Slide the Extension Pipes onto the outlet ends of the OEM H pipe.
Do not tighten yet.
Refer to Figure 7.
4. Join the Extension Pipes to the Over Axle Pipes. Be sure that the
supplied Clamps are installed over the joint. Do not tighten yet.
Refer to Figure 8.
5. Tighten all clamps just enough to hold the pipes in place but allowing
for adjustment.
6. Reattach the Panhard Bar Brace to the Driver side Frame rail with the
supplied M10x50 bolts and Spacers to allow more clearance for the
Drive Side Over axle Pipe. Install the Tips onto the Muffler outlets.
Refer to Figures 9 and 10.
7. Adjust the system to provide clearance between all other under body
components and hoses while ensuring the Tips are centered in the rear
Fascia. Tighten all clamps once properly adjusted.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your
MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10