MBRP S7104 - Manual (Page 3)

S7104 © 12/12 PAGE 3 OF 4
Installation of MBRP Inc. Performance Exhaust:
1. Slide two 2 1/2” Band Clamps over the remaining factory
exhaust pipes. Install the Extension Pipe Assemblies using the
2 1/2” Band Clamps leaving them loose enough for some
adjustment. Refer to Figure 5.
2. Slide two 3” Band Clamps over the Extension Pipe
Assemblies and install the Resonators onto the Extension Pipe
Assemblies. Refer to Figure 6.
3. Slide a 3” Band Clamp over the Resonator on the driver side
and slide the appropriate end of the Driver Side Tail Pipe into the
Resonator. Refer to the Illustration on Page 1. Slide the hanger
on the Driver Side Tail Pipe into the rubber insulator.
Refer to Figure 7.
4. Slide a 3” Band Clamp over the passenger side Resonator and
slide the appropriate end of the Passenger Side Tail Pipe, into the
Resonator Refer to the Illustration on Page 1. Slide the hanger
on the Passenger Side Tail Pipe into the rubber insulator. Note it
may be easier to remove the rubber isolator from the vehicle and
install it onto the Passenger Side Tail Pipe first.
Refer to Figure 8.
5. Attach the four M8 Exhaust Hangers to the frame where the
factory hangers were removed (two on each side).
Refer to Figure 9.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9