MBRP S7257 - Manual (Page 2)

S7260 © 07/13 PAGE 2 OF 3
- Mustang GT Race Series Cat Back
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber insulators.
2. Loosen both OEM clamps located at each muffler inlet, and both OEM
band clamps at the H Pipe outlet. Lift the lock tab to slide the band clamp
rearward. Do not discard these clamps.
Refer to Figures 1 and 2.
3. Remove the OEM over axle pipes by lowering the inlet ends and
pulling them out towards the front of the car.
4. Remove both M10 bolts that secure the Panhard Bar Brace to the Driver
Side Frame rail. Pull the brace downward to allow more room to remove
the OEM mufflers. Slide the rubber isolator off the rearmost muffler
hangers then slide the muffler assemblies forward and remove them from
the car.
Refer to Figure 3.
Installation of MBRP Inc. Performance Exhaust:
1. Install the Driver Side and Passenger Side Mufflers by inserting the 2
forward hangers into the OEM isolators and sliding the muffler forward
followed by inserting the rear hanger into the rear OEM isolators.
Refer to Figures 4 and 5.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5